South African FlagData loggers and ForestryPower Analyzers and Power stationsWind anemometers and weather stationsData logging and dam levelsMonitoring of Water flow and flow ratesControlling Farming and AgricultureEnvironmental monitoringFlow rates and pumps

Home Contact Us Search Site Sitemap

 

Up      

The Standard Series consists of a family of cable extension linear position and linear velocity transducers in a NEMA 1 (IP-40) housing. The transducer mechanism is housed inside of an aluminum cover and attached to an anodized aluminum baseplate with four mounting holes.

The measurement range determines which of three housing sizes is to be used. All of the possible UniMeasure analog and digital position outputs are offered in the Standard Series.

The wire rope exit is perpendicular to the baseplate as shown in the photo but optional side and bottom wire rope exit locations are available. Other options include nylon jacketed wire rope, dust wiper, terminal strip, non-standard potentiometer, and alternate connector location.

PA Series - Analog Position
PB Series - Analog Position
Ratiometric output voltage from a precision potentiometer configured in a voltage divider circuit. Requires regulated input voltage up to 25 V maximum.
Precision potentiometer in bridge circuit with integral zero and span controls which facilitate interfacing to a bridge amplifier. Requires regulated input voltage up to 25 V maximum.


Specifications
Specifications
P420 Series - Analog Position
P510 Series - Analog Position
Loop powered 4 to 20 mA current transmitter with adjustable zero and span controls. Input voltage is 12V to 35V depending upon total loop impedance.
Provides a 0 to 10 VDC or 0 to 5 VDC voltage output. Includes adjustable zero and span controls. Requires input voltage of 11 to 35 VDC (unregulated acceptable).


Specifications
Specifications
P1010 Series - Analog Position
EP Series - Digital Position
Provides a -10 VDC to +10 VDC or -5 VDC to +5 VDC voltage output with adjustable zero and span controls. Requires +15V, -15V and Common input. Single input voltages optionally available.
Digital, TTL level, two channel square wave output signal. 5 VDC input voltage. Optional configurations include 8 to 28 VDC, current sinking, push-pull & line driver capability


Specifications
Specifications
V Series - Velocity
VP Series - Velocity/Position
Ratiometric output voltage from a precision potentiometer configured in a voltage divider circuit. Requires regulated input voltage up to 25 V maximum.
Ratiometric output votage from a precision potentiometer configured in a voltage divider circuit. Requires regulated input voltage up to 25 V maximum.


Specifications
Specifications

Send mail to Webmaster with questions or comments about this web site.
Copyright 2018 Measurement & Control Solutions
Last modified: Measurement & Control Solutions
Last modified: January 15, 2018